How to Increase Your Golf Cart’s Speed (Without voiding your warranty)

AvatarByMatthew Woods How To Guides

How to Turn the Governor Up on a Golf Cart

Golf carts are a convenient way to get around a golf course, but they can be a bit slow. If you’re looking for a way to get a little more speed out of your cart, you can turn up the governor. The governor is a device that limits the speed of the cart, and by turning it up, you can increase the top speed.

Turning up the governor is a relatively simple process, but it does require some basic mechanical knowledge. In this article, we’ll walk you through the steps of turning up the governor on a golf cart. We’ll also provide some tips on how to safely operate your cart at higher speeds.

Before you begin, make sure you have the following:

  • A set of metric wrenches
  • A voltmeter
  • A Phillips head screwdriver
  • Safety glasses

Step 1: Locate the Governor

The governor is located on the engine of the golf cart. It’s a small, cylindrical device with a wire running to it.

Step 2: Turn Off the Engine

Before you can work on the governor, you need to turn off the engine of the golf cart. This will prevent you from getting injured.

Step 3: Disconnect the Battery

To disconnect the battery, locate the battery terminals and disconnect the negative terminal first, then the positive terminal. This will prevent any electrical shorts from occurring.

Step 4: Remove the Governor Cover

The governor cover is located on the top of the engine. It’s held in place by a few screws. Use a Phillips head screwdriver to remove the screws and remove the cover.

Step 5: Locate the Governor Adjustment Screw

The governor adjustment screw is located on the side of the governor. It’s a small, Phillips head screw.

Step 6: Turn the Adjustment Screw

Turn the adjustment screw clockwise to increase the top speed of the cart. Turn the screw counterclockwise to decrease the top speed.

Step 7: Reinstall the Governor Cover

Reinstall the governor cover and tighten the screws.

Step 8: Reconnect the Battery

Reconnect the battery terminals, starting with the positive terminal first, then the negative terminal.

Step 9: Test the Cart

Start the engine of the cart and test the top speed. You should be able to achieve a higher top speed than before.

Tips for Safely Operating Your Cart at Higher Speeds

  • Be aware of your surroundings and drive defensively.
  • Slow down for turns and obstacles.
  • Don’t tailgate other carts.
  • Use your horn and lights to signal your presence.
  • Always wear a seatbelt when driving your cart.

    Step Instructions Image
    1 Locate the governor on your golf cart. It is usually a small, black box located near the engine.
    2 Turn the governor to the desired setting. The setting is usually indicated by a number or a letter.
    3 Test the golf cart to make sure the governor is working properly.

    Tools and Materials Needed

    To turn the governor up on a golf cart, you will need the following tools and materials:

    • A Phillips head screwdriver
    • A flathead screwdriver
    • A wrench
    • A voltmeter
    • A soldering iron
    • A piece of solder
    • A heat gun
    • A piece of electrical tape

    Locating the Governor

    The governor is a device that limits the speed of a golf cart. It is typically located on the engine, near the carburetor. The governor is a small, metal box with a potentiometer inside. The potentiometer is a variable resistor that controls the amount of fuel that is sent to the engine.

    To locate the governor, you will need to follow these steps:

    1. Locate the engine on the golf cart.
    2. Look for a small, metal box with a potentiometer inside.
    3. The governor is typically located near the carburetor.

    Once you have located the governor, you can proceed to the next step.

    Turning the Governor Up

    To turn the governor up, you will need to follow these steps:

    1. Turn off the golf cart and disconnect the battery.
    2. Use a Phillips head screwdriver to remove the screws that hold the governor in place.
    3. Remove the governor from the golf cart.
    4. Use a flathead screwdriver to adjust the potentiometer.
    5. Turn the potentiometer clockwise to increase the speed of the golf cart.
    6. Reinstall the governor and tighten the screws.
    7. Reconnect the battery and start the golf cart.

    The governor is now turned up and the golf cart will be able to go faster.

    Cautions

    It is important to note that turning the governor up can increase the risk of engine damage. If you are not comfortable working on your golf cart, it is best to have a qualified technician do the work for you.

    Additionally, turning the governor up can void the warranty on your golf cart.

    Turning the governor up on a golf cart can be a simple way to increase the speed of your cart. However, it is important to be aware of the risks involved and to have a qualified technician do the work for you if you are not comfortable working on your own golf cart.

    Turning the Governor Up

    The governor on a golf cart is a device that limits the speed of the cart. It is typically located under the hood of the cart and is a small, black box with a knob or switch on it. The governor is turned up by turning the knob or switch clockwise.

    To turn the governor up, follow these steps:

    1. Locate the governor under the hood of the cart.
    2. Turn the knob or switch clockwise until the desired speed is reached.
    3. Be careful not to turn the governor up too high, as this could damage the engine.

    Once the governor is turned up, you should test the cart to make sure that it is running at the desired speed. To do this, drive the cart around for a few minutes and make sure that it does not exceed the desired speed.

    If the cart is exceeding the desired speed, you may need to turn the governor down slightly. To do this, turn the knob or switch counterclockwise until the desired speed is reached.

    Testing the Governor

    Once you have turned the governor up, you should test the cart to make sure that it is running at the desired speed. To do this, drive the cart around for a few minutes and make sure that it does not exceed the desired speed.

    If the cart is exceeding the desired speed, you may need to turn the governor down slightly. To do this, turn the knob or switch counterclockwise until the desired speed is reached.

    You should also test the governor by accelerating the cart quickly. If the cart does not accelerate as quickly as it did before the governor was turned up, then the governor is working properly.

    If the cart accelerates as quickly as it did before the governor was turned up, then the governor is not working properly and you will need to have it repaired.

    Turning the governor up on a golf cart is a relatively simple process. By following the steps in this article, you can easily increase the speed of your cart and enjoy a more enjoyable ride.

    However, it is important to note that turning the governor up too high can damage the engine. Therefore, it is important to test the cart after turning the governor up and to make sure that it is not exceeding the desired speed.

    If you have any questions about turning the governor up on a golf cart, you can consult your owner’s manual or contact a qualified mechanic.

    How do I turn the governor up on a golf cart?

    1. Locate the governor. The governor is a small device that limits the speed of the golf cart. It is usually located near the engine or transmission.
    2. Turn the governor screw. The governor screw is usually a small, Phillips head screw. Turn the screw clockwise to increase the speed of the golf cart, and counterclockwise to decrease the speed.
    3. Test the speed. Once you have turned the governor screw, start the golf cart and test the speed. Be careful not to exceed the posted speed limit.

    What are the risks of turning the governor up on a golf cart?

    There are a few risks associated with turning the governor up on a golf cart. These include:

    • Increased speed can make it more difficult to control the golf cart, especially at high speeds.
    • Increased speed can increase the risk of accidents.
    • Turning the governor up too much can damage the engine or transmission.

    How can I turn the governor down on a golf cart?

    To turn the governor down on a golf cart, simply turn the governor screw counterclockwise. This will decrease the speed of the golf cart.

    Can I turn the governor up on a golf cart without voiding the warranty?

    It is important to check the warranty before turning the governor up on a golf cart. Some manufacturers void the warranty if the governor is modified.

    What are some other ways to increase the speed of a golf cart?

    In addition to turning the governor up, there are a few other ways to increase the speed of a golf cart. These include:

    • Upgrading the engine or transmission
    • Installing a high-performance exhaust system
    • Using a lighter battery
    • Reducing the weight of the golf cart

    What is the best way to increase the speed of a golf cart?

    The best way to increase the speed of a golf cart depends on the specific model of golf cart. Some golf carts are easier to modify than others. It is important to do your research and choose the modifications that are right for your golf cart.

    In this blog post, we have discussed how to turn the governor up on a golf cart. We have covered the different types of governors, how to identify your governor, and the steps involved in turning it up. We hope that this information has been helpful and that you are now able to safely and effectively modify your golf cart’s governor.

    Here are some key takeaways from this blog post:

    • Golf carts have governors to prevent them from going too fast.
    • There are different types of governors, including mechanical, electronic, and GPS-based.
    • To identify your governor, you will need to know the make and model of your golf cart.
    • The steps involved in turning up the governor vary depending on the type of governor you have.
    • It is important to follow the manufacturer’s instructions when turning up the governor.
    • Turning up the governor can increase the speed of your golf cart, but it can also make it less safe.
    • You should only turn up the governor if you are experienced driving a golf cart and are aware of the risks involved.

    Author Profile

    Matthew Woods
    Matthew Woods
    Hello, fellow golf enthusiasts! I’m Matthew Woods, the founder of GolfPGAChampionship.com.

    My journey with golf is a story of passion, perseverance, and a little twist of fate. Growing up in the picturesque town of Charleston, South Carolina, I found myself captivated by golf, a fascination that was partly kindled by sharing a last name with the legendary Tiger Woods.

    This platform is more than just a website; it’s a culmination of my life’s experiences in golf. Here, I share in-depth analyses of PGA championships, personal anecdotes from my golfing journey, and tips for golfers at all levels. My aim? To make golf accessible and enjoyable for everyone, from eager beginners to seasoned players.

    GolfPGAChampionship.com is a testament to my belief that golf is not just a sport, but a journey filled with learning, challenges, and personal growth. I invite you to join me in this journey, to explore the beautiful game of golf through my eyes and experiences.

    Welcome to GolfPGAChampionship.com – let’s make every swing count!